HIAC PODS+ Online Mode

HIAC PODS+ Internal Compressor and Moisture Detector   

The internal compressor is connected to the airtight chamber/flow path in the HIAC PODS+. Air is compressed within the chamber that force bubbles to be compressed below sensor detection; thus, bubbles are not counted as particles as they pass by the laser and sensor. The internal Moisture Detector is an add on feature that monitors RH% with every run.

HIAC PODS+ Self-Diagnostic Alerts and Cleaning Routines

Operator purposely sampled fluid that exceeded 1000 cSt in viscosity so the PODS+ “Calibration voltage out of range” alert would trigger. The PODS+ is loaded with sensors that notifies the operator when the fluid exceeds coincidence level, air pressure too low, sensor is blocked, or the flow path is restricted/blocked. We alert the operator so sample fluid is not wasted nor analyzed for false answers. Two different Cleaning Routines allow the operator clean the sensor and/or the flow path to ensure accurate particle counting. This video also demonstrates both Cleaning Routines: Clean By Counts (analyzes particle counts while cleaning) and Clean By Volume (the amount of cleaning volume).

HIAC PODS+ Product Demonstration

Brief product demonstration highlighting the following features: Sample Recipe Wizard, Self Diagnostic Alerts and Cleaning Routines, Internal Compressor and Moisture Detector, Internal Compressor and Moisture Detector, Online Mode, Filter Cart Mode, and Digital Exports.

HIAC PODS+ Sample Recipe Wizard

Operator pushes buttons in a step-by-step product demonstration on how to create a new recipe. Operator inputs specific parameters such as Operating Mode, Tare Volume, Sample Volume, Number of Runs, Calibration, Reporting Standard etc. Once the operator assigns a unique parameter then they save the Recipe by assigning it with a unique name. This unique recipe name can be used over and over again by selecting recipe, pressing start, inserting sample, and then the sample is run through the HIAC PODS+.