With the ability to provide a simple, rapid method for removing chylomicrons (fat particles in lipemic samples), the Airfuge Air-Driven Ultracentrifuge delivers accurate results for lipemic clarification. Lipemic samples can be cleaned in 10 minutes, eliminating the need for sendouts.

Specifications

Max Speed 110,000 rpm
Max g-Force 199,000.00 x g
BioSafe No
Acceleration 30-60 seconds
Deceleration 2.5-5.5 minutes
Speed Control ± 5000 rpm of set speed
Timed Run Up to 5 hrs (5 min increments) or Continuous hold
Max Capacity Volume Range x 7 mL
Max Heat Dissipation 0.6 kW (1,800 BTU/hr)
Zonal Capability No
Imbalance Tolerance ±
Finish Control Panel: Silicone elastomer, Top Surface: Urethane paint, Other surfaces: General purpose paint
Weight 10.4 kg / 22.9 lb
Width 28 cm / 11 in
Depth 38 cm / 15 in
Height 20 cm / 7.9 in
Pollution Degree 2
Power Requirements 220 V, 50 Hz
UNSPSC 41103901

NOT ALL PRODUCTS ARE AVAILABLE IN ALL COUNTRIES
PRODUCT AVAILABILITY AND REGULATORY STATUS DEPENDS ON COUNTRY REGISTRATION PER APPLICABLE REGULATIONS

The listed regulatory status for products correspond to one of the below:
IVD: In Vitro Diagnostic Products. These products are labeled "For In Vitro Diagnostic Use."
ASR: Analyte Specific Reagents. These reagents are labeled "Analyte Specific Reagents. Analytical and performance characteristics are not established."
CE: Products intended for in vitro diagnostic use and conforming to European Directive (98/79/EC). (Note: Devices may be CE marked to other directives than (98/79/EC)
RUO: Research Use Only. These products are labeled "For Research Use Only. Not for use in diagnostic procedures."
LUO: Laboratory Use Only. These products are labeled "For Laboratory Use Only."
No Regulatory Status: Non-Medical Device or non-regulated articles. Not for use in diagnostic or therapeutic procedures.