The J26 XPI BioSafe Three-Phase centrifuge has upgraded accel/decel profiles from 2/3 to 12/13 and brings standard-setting performance, including high speed, low heat output, imbalance tolerance and low noise. Three-phase filtration means the machine can further separate the sluice into component solids, liquids and gasses, while the HEPA (high-efficiency particulate arrestance) filter kit makes this instrument BioSafe. Beyond its BioSafety, this centrifuge has a more impact-resistant lid, full containment barrier and automatic rotor identification. Its ergonomic design--with lower instrument height and hands-free door operation--remains unchanged. The J-265 XPI can process six liters of fermentor output in less than 10 minutes, deliver a subcellular fraction at 82,000 x g, run 24 microplates at a time. It automatically detects which rotor is installed and prevents the rotor from running above its maximum-rated speed, and enables quicker, quieter, more energy-efficient runs with enhanced temperature control. The exclusive high-torque, switched reluctance (SR) drive shortens cycle times.


Platform Avanti
BioSafe Yes
Acceleration Maximum, Slow or Timed (1-10 minutes, 0-500 rpm)
Deceleration Maximum, Slow, Timed (1-10 minutes from 500-0 rpm) or Off
Speed Control ±|10.00|rpm from 10,000 - 26,000 or equivalent RCF
Timed Run 1 min to 99 hr 59 min; 2t or Continuous hold
Max Capacity Volume Range 1.00|6.00|L
Software Virtual Network Computing (VNC), Mobile Fuge app for Apple iOS and Android
Temperature Range(s) 10°C - 40°C in 1 degree increments
Rotor ID Automatic
Zonal Capability Yes
Installation Category II
Environmental Conditions -10°C to 40°C in 1° increments
Humidity Restrictions < 95% (non-condensing)
Material(s) Steel, Plastic
Finish Polyster control panel with polycarbonate coating overlay, polyurethane enamel on door and covers, vinyl paint on other surfaces
Weight 290.00|kg / 639.340560336145|lb
Width 71.00|cm / 27.9527559055118|in
Depth 86.0, 102.0 with air direviter extending|cm / 86.0, 102.0 with air direviter extending|in
Height 86.00|cm / 33.8582677165354|in
Clearances 7.6 cm (sides) & 16 cm (rear)
Pollution Degree 2

Technical Documents


The listed regulatory status for products correspond to one of the below:
IVD: In Vitro Diagnostic Products. These products are labeled "For In Vitro Diagnostic Use."
ASR: Analyte Specific Reagents. These reagents are labeled "Analyte Specific Reagents. Analytical and performance characteristics are not established."
CE: Products intended for in vitro diagnostic use and conforming to European Directive (98/79/EC). (Note: Devices may be CE marked to other directives than (98/79/EC)
RUO: Research Use Only. These products are labeled "For Research Use Only. Not for use in diagnostic procedures."
LUO: Laboratory Use Only. These products are labeled "For Laboratory Use Only."
No Regulatory Status: Non-Medical Device or non-regulated articles. Not for use in diagnostic or therapeutic procedures.